Unidelta Compression Tee 50mm
Unidelta compression fittings can be used with LDPE, MDPE, PE40, PE80 water pipes. This relates to the outside diameter of the pipe and will form a strong durable hydraulic seal up to 16 bar pressure
- Made in Italy
- WRAS Approved
- Tee 50mm
- Strong secure grip ring
- Seal formed via O ring rather than rubber flap
The seal in Unidelta fittings is formed by an O ring rather than a rubber flap and this makes it much easier to fit if the pipes do not quite align.
Fitting instructions
- Remove the blue nut and slide this over the pipe
- Slide the white grip ring over the pipe and slide it back from the pipe end
- Make sure that the cut end of the pipe is square and clean. A bevel can be shape on to the pipe and this will make it easier to fit the fitting
- To ease installation a silicon gel can be applied to the end of the pipe and the O ring
- Push the pipe inside the fitting. The pipe will stop when it touches the O Ring
- Now push again and you will feel the pipe slide over the O ring. The pipe will slide beyond the O ring by between 12 and 20mm depending on the size of the fitting being used.
- Slide the white grip fitting up to the fitting
- Pull the blue nut down and tighten the fitting. Tighten the fitting so that it is hand tight and now continue to tighten the blue nut with some grips. Do not over tighten the fitting