Push Fit Reducer 20 - 12mm Per 100

Barbed Reducing Straight Connector 20mm - 12mm 

Used to reduce 20mm LDPE outside diameter pipe to 16mm.  This is ideal when you are using long runs of pipe. Using 20mm pipe over long runs will make sure that you loose as little water flow as possible as the water can run slower through the pipe and so there is less frictions.  

The connector is made from a strong industrial grade UV stabilised plastic.  The connector can be used on any thin walled pipe like LDPE water pipe or Netafim pressure compensated drip pipe.  

• Simple push fit connector 
• Can be used to join pipes together with a 12mm outside diameter 
• UV stabilised plastic 
• Once fitted the joint is rated to 6 bar 
• Made in Greece 

Fitting 

These more industrial type push fit fittings have a much larger and sharper barb than the more retail fittings.  Because of this more effort is required in order to fit these to the pipe.  The end of the pipe that needs joining should be heated using either very hot water or some form of blow torch.  If you do use a blow torch then the end of the pipe should be positioned in the flame for 2 seconds if the pipe is black and 1 second if it is brown.  The flame should be directed down the centre of of the pipe rather than on 1 side.  Now push the barbed fitting in to the pipe.  If you have overheated the pipe it will fold back on itself.  If this is the case cut the pipe to a clean point and try again.  Once the fitting is in they can only be removed by cutting the pipe.  These are extremely durable and will give you piece of mind when leaving you irrigation systems