Your cart is empty.

Cards Accepted

VisaMasterCard / MasterCard DebitVisa DebitMaestroVisa Electron (UKE)CEON_SAGE_PAY_FORM_CARDS_ACCEPTED_SIDEBOX_AMEXPayPal
Verified By Visa MasterCard SecureCode
Secured by Sage Pay
Card payment processing powered by Ceon software

Unidelta MDPE Compression Reducer 50mm - 32mm

Unidelta MDPE Compression Reducer 50mm - 32mm

Unidelta compression fittings can be used with LDPE, MDPE, PE40, PE80 water pipes. This relates to the outside diameter of the pipe and will form a strong durable hydraulic seal up to 16 bar pressure
  • Made in Italy
  • Reduces 50mm pipe to 32 mm
  • Strong secure grip ring
  • Seal formed via O ring rather than rubber flap
The seal in Unidelta fittings is formed by an O ring rather than a rubber flap and this makes it much easier to fit if the pipes do not quite align.
Fitting instructions
Remove the blue nut and slide this over the pipe
Slide the white grip ring over the pipe and slide it back from the pipe end
Make sure that the cut end of the pipe is square and clean. A bevel can be shape on to the pipe and this will make it easier to fit the fitting
To ease installation a silicon gel can be applied to the end of the pipe and the O ring
Push the pipe inside the fitting. The pipe will stop when it touches the O Ring
Now push again and you will feel the pipe slide over the O ring. The pipe will slide beyond the O ring by between 12 and 20mm depending on the size of the fitting being used.
Slide the white grip fitting up to the fitting
Pull the blue nut down and tighten the fitting. Tighten the fitting so that it is hand tight and now continue to tighten the blue nut with some grips. Do not over tighten the fitting


  • Model: UNI701653
  • Shipping Weight: 120lbs
  • 4 Units in Stock
  • Manufactured by: Unidelta

Be the first to write a review.  Write a Review.

This product was added to our catalog on Thursday 29 April, 2021.